This advanced membrane works by a hydrostatic pressure-driven process where water pushes through the tiny pores and particles larger than 0.05 micron are blocked.  The pore size on this ultrafiltration membrane is an absolute (100%)  0.05 micron (thats about 4x Smaller than the smallest bacteria which is 0.2 micron) and may be used on water where microbiological issues exist.  e.g. Well Water.

All components comply to FDA Food Grade Quality Standards.

Why Our UltraFiltration Membrane is Better than Reverse Osmosis:

1. It cannot “break-through” and allow impure water to pass through.
2. It does not waste 3-7 gallons of water for every 1 gallon filtered.
3.It is much more affordable & lasts for approximately 3 years.
4.It allows for crucial natural minerals to pass through.
5.It Does not require a water storage tank & fits any standard 10” filter.

CLEANING INSTRUCTIONS:

Fully submerge the membrane into 3-5% Hydrogen Peroxide liquid during your normally scheduled cartridge changes for a period of 12 hours.  After 12 hours remove the membrane and rinse under warm water, then install it back into your system.  Flush the system with cold water for 5 minutes before use. You may also steam (not boil) the membrane in a wide enough pot in a strainer, low flame, covered with a lid for 30 minutes, then rinse well.